Panasonic ET-EMW500 Standard Throw Projector Lens: Compatible with 19 Models Including PT-MZ20KL

Panasonic Original Lens ET-EMW500 is a genuine optical accessory for Panasonic professional projectors. It belongs to the standard throw range, with a throw ratio of 0.950-1.36:1, designed for 1.0" 3LCD panels. The original compatibility list covers 19 projector models; simply verify against the projector model and panel size before installation—no adapter rings needed. The value of an original lens isn't in a few extra rows of numbers on a spec sheet, but in the fact that it is calibrated at the factory to the optical path and mount of that projector series: once installed, the image circle, edge illumination, and focus travel all match design values, so you don't need keystone correction to compensate for image quality.

1. Lens Specifications

The above specifications are subject to the original manufacturer's specifications. For mechanical dimensions, flange focal distance, and mount type not shown in the spec table, please verify with us against your projector model—ordering based on model similarity alone carries the risk of incompatibility.

2. Converting Throw Ratio to Installation Distance

Throw ratio is the ratio of installation distance to image width. This original lens is a zoom lens (0.950-1.36:1), so the same image size corresponds to a range of distances; as long as installation falls within this range, focus can be achieved.

The above figures are the clear distance from the lens front to the screen, excluding rear ventilation and cabling space. Calculated for 16:10 aspect ratio; actual values are subject to on-site measurement and the original manufacturer's manual.

Image quality differs at the two ends of the zoom range: toward the near end the image is brighter with slightly softer edges; toward the far end the edges are sharper with slightly reduced brightness. Where space permits, we recommend landing in the middle of the range; after installation, first find the sharpest position on the focus ring, then fine-tune the shift.

3. Compatible Models (19)

The table below is taken from the original manufacturer's compatibility list; brightness and resolution are filled in from the model database, with "—" where unavailable, without speculation.

For models not on the list, please send us photos of the projector nameplate and the existing lens for verification—same-generation platforms often share mounts, but ordering based on model similarity is a risk not worth taking.

Throw Ratio Across Model Series

The same ET-EMW500 mounted on the following series does not have the same nominal throw ratio; selection must be based on the actual series of the projector.

4. Three Things to Confirm Before Replacement

• Panel size must match. The ET-EMW500 is designed for 1.0" 3LCD panels. Projectors with a different panel size or resolution may have the mount fit, but the image circle and edge illumination will suffer.
• Calculate installation distance first. This lens has a nominal throw ratio of 0.950-1.36:1; use the table in Section 2 to match your venue dimensions. Fixed focal length has no margin, and even with zoom you should allow 10–20 cm at both ends.
• Verify mount and locking. The original lens is calibrated to the mount of that projector series; after installation you must hear it lock into place. Image skew and soft edges are usually due to incomplete locking, not a problem with the lens itself.

If unsure, take a photo of the projector nameplate and the existing lens nameplate and send them to us—verifying against the actual hardware is the safest approach.